Common Problems When Using Automatic Balancing Machine

In the daily operation and use of the automatic balancing machine, some minor problems occasionally occur. Some problems are caused by the workpiece itself, and some problems are caused by the balancing machine itself. These problems affect the accuracy of the balance at a minimum, and cause the balancing machine to fail to complete the work normally. So what will affect the work of the automatic balancing machine? How can we solve these problems?

Factors that cause the balance machine to not work properly
1. The influence of the artifact itself
When the balance accuracy cannot meet the workpiece balance requirements
When the roundness of the support of the workpiece itself is not good
When the rigidity of the workpiece itself is not good
When the actual working status of the workpiece is inconsistent with the balance check status.
2. The influence of the balancing machine itself
The foundation on which the balancing machine is installed does not meet the requirements, which is likely to cause resonance
The left and right supports are not at the same horizontal line, which will easily cause the rotor to move left and right
Sensor output signal is abnormal
The photoelectric head of the balancer is not aligned with the reflective paper, which may cause the angle to shift
There are many situations in which the balancing machine cannot work normally due to the problem of the workpiece itself and the reason of the balancing machine itself. Therefore, when purchasing a fully automatic balancing machine, the details of the workpiece must be described clearly, and the machine needs to be fully debugged before the fully automatic balancing machine is put into use.

1-200ZQ9191R94